Drinking water quality · 2011

· PWSID PR0633076

What's in Janssen Ortho, Llc, PR tap water

F
Water quality score
51/ 100Limited data

Only 1 of 27 core regulated contaminants were reported for Janssen Ortho, Llc, PR. What was measured is not clean — but most of the picture is missing.

  • !1 contaminant at or above a federal limit — worst is Lead at 1.2x
  • !1 of 27 core regulated contaminants reported — 26 never appear in this report
  • No open federal violations
+How this score is calculated

Every system starts at 100. Points come off for measured levels, for the federal violation record, and for how much of the core regulated set the utility actually reported. All three inputs are the utility's own published numbers and EPA's own records.

  • 15  contaminants at or above a federal limit
  • 0  contaminants within 20% of a limit
  • 0  open health-based violations
  • 0  open monitoring / reporting violations
  • 6  health-based violations resolved in the last 5 years
  • 28  core regulated contaminants never reported (1/27)

A 90–100 · B 80–89 · C 70–79 · D 60–69 · F below 60. A system reporting under a third of the core set is capped at C however clean its numbers look — a short report is not a clean bill of health.

Full grading methodology, constant for constant →

What to worry about

  • Lead1.2× the federal limit
    0.018 mg/L · limit 0.015 mg/L

    There is no safe level of lead; it harms brain development in children and raises blood pressure in adults. The EPA sets an action level, not a health goal above zero.

    Higher than 95% of PR systems that report it · higher than 95% of U.S. systems

What this report doesn't tell you

26 of the 27 contaminants a community water system normally reports do not appear anywhere in Janssen Ortho, Llc, PR's data. Absent is not the same as absent-from-the-water — it means nobody published a number.

CopperArsenicNitrate / nitriteFluorideTrihalomethanes (TTHM)Haloacetic acids (HAA5)Disinfectant residualColiform bacteriaTurbidityBariumChromiumSeleniumAntimonyCadmiumMercuryThalliumBerylliumCyanideRadiumGross alpha radiationUraniumAtrazine / simazineTetrachloroethylene (PCE)Trichloroethylene (TCE)BenzenePFAS
Browse the mapFull source report ↗
+Full detail: PFAS testing, water source, historical monitoring, and the federal violation record

Compliance history

Federal Safe Drinking Water Act violation & enforcement records (EPA SDWIS). A violation is a regulatory determination by the state or EPA — separate from the measured levels above.

  • Maximum contaminant level exceededHealth-based
    3 violations on record · most recent Jul 2019
    resolved
  • Treatment technique violationHealth-based
    1 violation on record · most recent Oct 2024
    resolved

Source: EPA SDWIS / ECHO. View the full federal record on EPA ECHO ↗

Source: Janssen Ortho, Llc, PR's 2011 Consumer Confidence Report — the annual drinking-water report every U.S. utility is required to publish. The numbers on this page are the utility's own. A water-quality report covers an entire service area, not a single address.
The grade at the top of this page is computed, not editorial. See exactly how we grade water systems — every deduction, every ceiling, every threshold.

More water systems in PR